BP 14 RF

For water drainage on insulated façades (external thermal insulation systems).

No risk of cracking at joints, unlike traditional drip profiles (250 cm and 300 cm lengths), thanks to the use of a continuous 25-meter profile
Compact packaging: low-cost courier shipping and easier storage
No material waste: can be cut precisely to the required length
Recommended in combination with the BP27 starter profile

The profile must be installed wherever water needs to be drained away from the façade:

above the base (plinth), under terraces, balconies, cornices, above windows, or in any area where water could penetrate beneath projecting elements.

Open the packaging and unroll the strip.
Cut the required length.
Remove the yellow protective film from the adhesive tape.
Fold the strip in half, with the adhesive side inside, and press along the entire length.
Extend the small arm outward to form the profile angle.

The profile is then ready for installation.

Position the profile with the long arm vertical.
Embed the integrated fiberglass mesh into the adhesive used for façade reinforcement (polystyrene or mineral wool insulation).
Spread the adhesive evenly over the insulation.
Embed the profile mesh, then immediately cover it with the façade system mesh,
with a 10 cm overlap.
Both meshes must be embedded in a single operation to form a homogeneous layer.
After drying, apply the render, ensuring the profile cavity is completely filled.